Archived:Jigsaw Introduction

From CoMakingSpace Wiki

Revision as of 20:27, 23 May 2018 by Lukas (talk | contribs) (Created page with "This is the content required for an introduction to our jigsaws - '''reading this does NOT replace the mandatory session with a tutor!''' It will make it a lot quicker...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

This is the content required for an introduction to our jigsaws - reading this does NOT replace the mandatory session with a tutor! It will make it a lot quicker though ;-)

Let's begin! First off, make sure you have read the tool's manual (Parkside PSTD 800 A1: pdf here).

Safety

Dangers

  • sharp oscillating blade
  • generates dust and small chips
  • generates noise
  • no prevention of turning on after loss & restoration of power (keine Anlaufsicherung)

Precautions

  • make sure the blade path is free
  • wear goggles
    • perhaps also wear a dust mask (depending on the material you're cutting)
  • wear ear defenders
  • hook up the shop vac (and deactivate the "dust blow" function of the saw, if available)
  • make sure the locking lever isn't "on" before plugging the saw in (the trigger should move freely)

Demonstration

Besides these safety notes, you should know which type of blade is suitable for the saw you want to use and how to change blades - the tutor will show you!