Welding Helmets

From CoMakingSpace Wiki

ToolInfoBox

Tacklife PAH01D

Tacklife PAH01D.JPG
Synonyms: welding masks, welding hoods,
welding shields, welder helmets,
welder masks, welder hoods;
DE: Schweißhelme, Schweißerhelme,
Schweißmasken, (Kopf)Schweißschilde,
Schweißschirme, Schweißerschutzhelme
Type: personal protection
Used with: welding transformer
Location: welding area in the metal workshop
Access Requirements: read this page & the manual
Tutors: Lukas
Manual: in each bag; product website with schematic
Similar (More or Less): face shields

We have two auto-darkening welding helmets that will protect your eyes and face during welding sessions.

Before Use

  • select the correct shade number and sensitivity for your application
  • select "Weld" or "Grind" mode, depending on what you want to do
  • check that no dirt is covering the four sensors around the filter
  • check for scratches or cracks and report them immediately so the glass can be replaced if necessary (more are available in the storage room)
  • adjust the headband so that the helmet is as low as possible on your head and close to your face
  • check for light tightness
  • if the helmet does not darken properly when you start welding or grinding, stop immediately until you've found the problem!

Settings

Shade Selection

For SMAW, the manual states these appropriate shade numbers (depending on current):

  • 20-40 A => #9
  • 40-80 A => #10
  • 80-175 A => #11
  • 175-300 A => #12
  • 300-500 A => #13

If necessary, make adjustments based on your weld - you should be able to see the welding spot and the pool of hot metal but no unpleasant glare.

Sensitivity

The sensitivity should be set as high as possible without darkening because of ambient light. The helmet should then darken immediately upon ignition of the welding arc.

Delay

The delay setting regulates how long the filter stays dark after the light burst. A longer delay should be set when the welding pool continues to blind you after interrupting the arc or the filter flashes between light and dark.

Storage

Keep the helmets in their bags to reduce exposure to light, this is supposed to make them last longer.